If your motherboard does not support a common ground on the PWR_SW pins, short pins 2-3 on J6701 otherwise connect pins 1-2. Log in, and then from the Configuration menu, choose Time. If your motherboard does not support PCI_WAKE# signal:Ĭonnect the J6703 to PWR_SW pins on the motherboard (power cable not included). Go to the IP address of the zero client (or host card) from a browser.If required, configure the system BIOS and host card AWI to enable 'Wake by PCIe device.' More information in How does the PCoIP Zero Client/PCoIP Remote Workstation Card support remote power management?. Note: This method is considered standard WOL, using an external signal.Your motherboard must support the PCI_WAKE# signal (check with your motherboard supplier to see if this is supported).For instructions, refer to How do I remotely power on the host PC/workstation through its network interface (PC NIC) from a PCoIP Zero Client?. The SAPPHIRE ZC400 PCoIP Zero Client is a small format, stylish and fanless design for a powerful zero client solution based on the Teradici TERA2140.Option 1: Use the PC NIC and PCoIP Host Software There are three ways to configure wake-on-LAN with the AMD R5000 PCoIP Remote Workstation Card.

Teradici pcoip wake on lan zero client